计算物理 ›› 2014, Vol. 31 ›› Issue (3): 331-334.

• 研究论文 • 上一篇    下一篇

沉降分布孔隙率多孔介质模型及数值研究

杨伟1, 薛思瀚1, 刘秦见1, 张树光2   

  1. 1. 辽宁工程技术大学建筑工程学院, 阜新 123000;
    2. 辽宁工程技术大学土木与交通学院, 阜新 123000
  • 收稿日期:2013-06-26 修回日期:2013-10-17 出版日期:2014-05-25 发布日期:2014-05-25
  • 作者简介:杨伟(1965-),男,辽宁阜新,副教授,研究方向为流固耦合传热机理,E-mail:lgdyw@163.com
  • 基金资助:
    国家自然科学基金(50804021)资助项目

Model of Porous Media with Settlement Distributed Porosity and Numerical Study

YANG Wei1, XUE Sihan1, LIU Qinjian1, ZHANG Shuguang2   

  1. 1. School of Architecture Engineering, Liaoning Technical University, Fuxin 123000, Liaoning, China;
    2. School of Civil Engineering and Transportation, Liaoning Technical University, Fuxin 123000, Liaoning, China
  • Received:2013-06-26 Revised:2013-10-17 Online:2014-05-25 Published:2014-05-25

摘要: 研究沉降分布孔隙率多孔介质流动和传热,根据"O"形圈理论和现场测定确定孔隙率系数,建立坐标方向孔隙率分布函数;考虑流体密度变化,并引入Brinkman-Forchheimer的扩展Darcy模型,能量方程采用界面连续条件,建立沉降分布孔隙率多孔介质流动和传热求解模型.采用差分法对模型进行离散化,应用高斯-赛德尔方法迭代求解.数值分析表明:沉降分布孔隙率条件下多孔介质内流体流动速度在壁面附近较大,中心部位较小,壁面附近孔隙率的增大使得低流速区域减小,较高流速区域增大;当孔隙率小值时,温度按线性减小;当孔隙率大值时,温度在高低温壁面附近迅速减小,在中部减小较缓,热量按导热和对流共同传递;孔隙率增大能使平均怒谢尔数增大,对流换热作用增强.

关键词: 沉降分布孔隙率, Darcy模型, 多孔介质, "O"型理论

Abstract: Flow and heat transfer in porous media with settlement distributed porosity is studied. Based on ‘O-shape’ ring theory and in situ measurement, a distribution function of porosity in x direction is established. Considering change of fluid density, Brinkman-Forchheimer-extended Darcy model is introduced. Energy equation is solved with continuity boundary conditions. A model of flow and heat transfer in porous media with settlement distributed porosity is established. The model is discretized with difference method. Gauss-Seidel iteration method is used. Numerical analysis shows that:Fluid flow velocity in porous media with of settlement distributed porosity is greater near wall surface, and it is small at center. Increase of porosity near wall surface reduces low velocity zone and increases high velocity zone. As porosity is small, temperature decreases linearly. As porosity is large, temperature near high and low temperature wall surface reduces rapidly. The decrease becomes slower at center. Heat is transferred through conduction and convection together. Increase of porosity increases average Nusselt number and enhances heat convection.

Key words: settlement distributed porosity, Darcy model, porous media, "O-shape" ring theory

中图分类号: